Before treatment

Cleanse the skin so that it is clean, dry and without makeup. Then select a suction head. At the first treatment, the diamond head is recommended.

Switch on the machine at the lowest suction power and test it on the back of the hand. This is recommended to practice angling and movement before using it on the face. Wait 5 minutes to see the reaction of your skin before proceeding.

The face can be steamed before treatment to open and relax the pores. This is done either using a facial steamer or by letting the steam from boiling water hit the face for 5-10 minutes. However, this is not a requirement.

During treatment

The machine has 4 suction powers. On the first treatment, it is important to use only the lowest and thus most gentle suction power. With subsequent treatments, you can gradually increase the suction power. Exception: If you want to remove blackheads around the nose with the small suction head, suction strength 3-4 can be used.

The treatment is performed by gently moving the machine over the natural lines of the face using fast, smooth strokes. Avoid treating an area more than 2-3 times and do not hold the machine in the same place for several seconds.

Stop treatment if you experience pain. Pain may be due to the suction power being too high, the machine being held in the same place for too long, or an area being overtreated.

Post treatment

Remove the suction head and cleanse with water and possibly a cotton swab. It is also recommended to disinfect the suction head with rubbing alcohol.

Rinse your face with cold water to close the pores and soothe the skin. It is important that the skin gets plenty of moisture. Therefore, finish with your regular face cream or mask.

Learn after each treatment and adjust to suit your skin going forward.